Hello friends and associates. I wanted to let you all know about Surface Fabrication's first ever "Webinar," which is taking place tomorrow (Dec. 14) at 1 p.m. Central Time. Basically, we have put together an online seminar that allows fabricators from anywhere to log into our Web site and sit in on a live webcast on the subject of digital templating. The event is sponsored by Fabricators Choice, Laser Products Industries and ETemplate, and each of these entitities will be presenting information on digital templating and their digital templating products. There are also plenty of opportunities for you to ask specific questions. The event is free to all of you, and should be a great way to investigate the world of digital templating. You can read more about it and/or sign up for it at http://www.surfacefabrication.com/webcasts.

I hope to see you all there.

Best,

Kevin Cole, editor & associate publisher, Surface Fabrication magazine

Thanks Tom. I hope you find it useful. If you are able to attend, please drop me a line and let me know what you thought about it.

Best,

Kevin

Kevin,

I got signed up to. Need to remember to set my alarm clock in shop so I do not forget. Thanks for putting someting like this together.

Reuben

Also thanks for mentioning it in central time zone, I also get confused with Eastern, pacific mountain etc.

Kevein

  WE GOOD

     Mory

Thanks for the warm reception, guys. I really think this seminar is going to be a very good thing and I am glad to receive the support from my friends at The Fabricator Network. Any of you that signed up should be receiving a link via e-mail and a code to put in so you can access the Webcast. Please feel free to call or email me if you have any problems. My e-mail is editor@surfacefabrication.com and my direct phone number is 920-563-1694 (and please don't write it on any bathroom walls, lol).

Thanks again,

Kevin

I am checking on the code thing now. Maybe I was wrong about it. I will let you know as soon as I know.

Thanks,

Kevin

Apparently there is not a code needed, just click the link you receive in your e-mail and that should be enough. Sorry about that.

Kevin

Kevin,

I signed up but I don't have the link to get on the webcast.  I couldn't open one of the emails you sent so if you could resend that would be helpful.

Thanks

Heya Andy:

I sent the link to your andy@thefabricatornetwork.com e-mail address. Hopefully you can open it. Let me know if you have problems.

Kevin

Kevin:

Congradulations, the web thing on digital templating was cool.

You sent me several emails urging me to sign up, even after I registered. At about 1:58 p.m.EST, I tried to connect but couldn't. I called your office to see what the matter was while I reregistered. By the time the office people got to me, I had reregistered and the "connect" button appeared. I missed the first eight minutes or so I think.

Joe

Tom:

We did ask the line of sight question and Dan addressed it. Sorry you missed it. However, we will be posting the Webcast on our Web site (www.surfacefabrication.com) very soon, so you can go back and hear the answer. Also, you can always contact any of the participants directly.

As for the Faro Arm, they were invited to be a sponsor, but apparently did not wish to take part. We also invited the folks that make the Proliner with the same results.

Thanks again to all of you that sat in. There were more than 150 people register -- a great turn out. I will post a link to the archived Webcast here when it becomes available.

Finally, I am so happy there were only minor problems with the technology. I'm glad you got in Joe. It is very scary to put so much into a relatively new technology.

Thanks again everyone, I hope you found it useful.

Sincerely,

Kevin